What programmer to use?

Use CarProg programmer with:

• For Nissan modules with Infineon processors use S5.44 Nissan Altima 2013 airbag sensor with Infineon programming by OBDII software.
  (CarProg does not read Nissan Qashqai and Rogue airbag modules with Infineon processors, contact paulius@codecard.lt and we will give you all information on how to read those modules)
• For Nissan modules with 95128 eeprom use 2014 Update for Airbag Software using Direct EEPROM/MCU connection software.

How to read Nissan airbag modules with Infineon processors in car by OBD?

You will need:

• CarProg programmer with required software
• A1 or A1 MULTI adapter

Reading procedure:

1. Connect CarProg to car by OBD using A1 (or A1 MULTI) adapter
2. Select required software:
   • ALTIMA XC2361 DIAG for Nissan Altima modules with Infineon processors
   • MURANO XC2361 DIAG for Nissan Murano modules with Infineon processors
   • SENTRA XC2361 DIAG for Nissan Sentra modules with Infineon processors
   Always use same software for reading and writing! You must NOT read with one software and write with another. You can damage module.
3. Press read button
4. Upload crashed file to our online crash cleaner, there are two ways to do it:
   • Save file to your computer and upload it manually to our online crash cleaner
   • Press cloud button and CarProg will upload your file to our online crash cleaner automatically
5. You will get clear file immediately after payment for clearing.
6. Write clear file to your module (Use the same software as used for reading!)
7. Turn car ignition off than on and clear faults with diagnostic.

How to read Nissan airbag modules with Infineon processors on bench?

You will need:

• CarProg programmer with required software
• A1 or A1 MULTI adapter
• C1 adapter

Reading procedure:

1. Connect CarProg to car by OBD using A1 (or A1 MULTI) and C1 adapters
   Connect 500 Ohm resistor between CAN (yellow and green) wires.
   • Connection diagram for Nissan with Infineon processor airbag modules
     
2. Follow same procedure as on car.

Something is not working?

You used online crash cleaner, wrote clear file to module but airbag light is still flashing and diagnostic shows crash fault?
Clear all faults with diagnostic. Crash fault should clear.

You still have some problems?
Contact us by email: paulius@codecard.lt

Works with all Nissan modules with Infineon XC2336B processors.