S7.14 - Dashboard with NEC repair by OBDII for VW, Skoda, Seat 2009+

Product Information
Works with CarProg A1 cable.

Supported cars:

• VW Golf 6 - 2009+ with NEC and 24C32, 24C64 EEPROM - odometer repairing and immobiliser data read (PIN code, Component Security, keys) by OBDII;
• VW Passat , Passat CC - 2009+ with NEC and 24C32,  24C64 EEPROM - odometer repairing  by OBDII;
• VW Tiguan - 2009+ with NEC and 24C32,  24C64 EEPROM - odometer repairing and immobiliser data read (PIN code, Component Security, keys) by OBDII;
• VW T5 - 2009+ with NEC and 24C32,  24C64 EEPROM - odometer repairing and immobiliser data read (PIN code, Component Security, keys) by OBDII;
• VW Polo  - 2009+ with NEC and 24C32 EEPROM - odometer repairing and immobiliser data read (PIN code, Component Security, keys) by OBDII;
• Skoda Octavia 2009+ with NEC and 24C32,  24C64 EEPROM - odometer repairing and immobiliser data read (PIN code, Component Security, keys) by OBDII;
• Skoda SuperB - 2009+ with NEC and 24C32 EEPROM - odometer repairing and immobiliser data read (PIN code, Component Security, keys) by OBDII;
• Skoda Roomster, Yeti - 2009+ with NEC and 24C32, 24C64   EEPROM - odometer repairing and immobiliser data read (PIN code, Component Security, keys) by OBDII;
• Seat Ibiza - 2009+ with NEC and 24C32,  24C64 EEPROM - odometer repairing and immobiliser data read (PIN code, Component Security, keys) by OBDII;

C1 Car electronic testing on table adapter

If you see the immo lamp is on (immo is active)  or you see the message "Unknow version or Immo Active"  you must:

1. Remove dashboard from car and read it's eeprom 24C32 or 24C64 manualy (using carprog eeprom software and A6 adapter)
2. Save this eeprom dump to have backup
3. Fill eeprom dump : 
    [VAG with NEC MCU + 24C32 inside]  - range 0xCC0 - 0xEAF in hex editor with FF FF ..
    [VAG with NEC MCU + 24C64 inside] -  range 0x12E0 - 0x14CF in hex editor with FF FF ..
4. Write this damaged dump to eeprom (using carprog eeprom software and A6 adapter)
5. Put dashboard back to car and connect via DIAG now
6. Load your saved backup (original eeprom) and press write
7. After write compleate you can read PIN repair km etc..

after modification dump file's must look like :

[VAG with NEC MCU + 24C32 inside]

[VAG with NEC MCU + 24C64 inside]

(without VAT)

• Tell a Friend