Speedstop's Support
Downloads and Manuals
Price List
Contacts
UAB "Atomis" Ent. Code: 300091017,
Taikos str. 127C,
Kaunas 50472, Lithuania
Sales: sales@codecard.lt
GSM: +370 616 16161 Technical Support:support@codecard.lt
Technical Support for Speedstop & other emulators ONLY! GSM: +37069255738 +Viber support@codecard.lt
Office is open:
I-V, 9 a.m. - 6 p.m.
(GTM+02.00)
Carprog Manual
Language
Currency
Audi A4 2006 immo deading error
| Krisztian | 2010-02-24 22:33:07 | ||||||||||||
| hello support! I tried read the pin of the A4 2006 RB8 dash, but it not possible. I get the error message:( Carprog->immo->Audi RB8->read immo. Can anybody help me? |
|||||||||||||
Quote  |
|||||||||||||
 Reply |
| Agostino | 2010-02-26 22:51:05 | |||
| Post the error message and at least the scan for the instrument cluster. I did the same model and the cluster part number is 8E0 920 901 E with version KOMBI+WFS 4 Address 17: Instruments Part No SW: 8E0 920 901 E HW: 8E0 920 901 E Component: KOMBI+WFS 4 H12 0110 Revision: 0110 Serial number: 00000000000000 Coding: 0023361 Shop #: WSC 93030 999 79353 My version was a success. Make sure you complete your updates for the CarProg, that includes the system board update. If you have CAN Bus faults in the system, repair them first. A clean DC power supply needs to be attached to the battery before any diagnostics are performed. |
||||
| Quote |
||||
| Krisztian | 2010-02-27 15:24:58 | |||
| Hello Agostino! My carprog updated the last version (3.34?) and i connected battery charger and terminal30 is 12,8V. No can comunications fault stored, and data bus is two wire. All control mudules are not stored fault code. Part: Address 17: Instruments Part No SW: 8E0 920 900 Q HW: 8E0 920 900 Q Component: KOMBI+WFS 4 H12 0030 Coding: 0006141 Shop #: WSC 00158 Thanks |
||||
| Quote |
||||
| Krisztian | 2010-03-02 13:08:25 | |||
| Fault message is "No response from unit" | ||||
| Quote |
||||
| Agostino | 2010-03-04 10:20:03 | |||
Your version is the newest and I have tried that same model year on an older version with success.  Most other models are tested on the bench but the image posted is through the DLC. Make sure other functions are correct with the CarProg. Try to connect with another device like a cluster or airbag controller to test. Make sure there are no other devices installed in the A4 that doesn't belong such as an aftermarket radio. If the CarProg works and still can't communicate, remove the cluster in question and bench test. If that fails, contact support. They may have another solution. |
||||
| Quote |
||||
| Reply |