Roberto		2011-03-10 20:53:15
Hello Ramis carprog.V04.08 read fault memory unknow ???? dashboard. carprog >2007v0.4:2007>v0.4:2008 v0.4 Golf5,passat,Jetta+micronas, ERROR UNKNOWN OR IMMO ACTIVE I CAN'T CALIBRATE THIS KM. OFF DISPLEI DASHBOARD. the same problem: kombi instrument VDD 1K0 920 853Q v.14.45 1T0 920 826F VDD SW V.08.87 3C0 920 852J VD1 SW V.14.45 ecc.ecc. Risolver urgent poblem.thanks
Quote

Reply

Jorge		2011-03-11 00:17:08
hi,, try to work in desk using C1 cable ( extention of OBD II with wires )
Quote

Kavan		2011-04-13 02:04:55
hi jorge i too have the same problem the touran 2007, unknown version, also tried other other equipment but no good, found micronas cdc3297g processor. i need to know to read on desk? what is c1 cable and is there a wiring diagram. this is urgent as all keys are lost/stolen and customer is going on holiday in a few days many thanks
Quote

raimis		2011-04-21 22:14:08
hi, all VW models (except passat) needs valid key to programm is not good if dash is connected on the table - immo will be active in case you have SAFE or ERROR on display use this sequence to skip immo checking 1. open dash and find 24C32 eeprom inside 2. read and save original eeprom 3. fill block 820 - 91F with FF and write 4. display will show ERR or DEF but immo check will be disabled so dash can be programmed on the table without valid key 5. after dash programmed (EEPROM read button pressed) you can upload original dump and write it 6. after original dump upload you can do anything you need Raimis
Quote

Mariusz		2011-09-03 03:33:38
Witaj Ramis Golf 5 2007 rok , w liniach 820 do 91F u mnie są same FF , a identyfikacja immo jest włączona i carprog nie czyta i nie zapisuje, licznik w aucie brak zaprogramowanego klucza, czy te linie są prawidłowe pozdrawiam
Quote

segun		2013-08-26 16:28:13
Ramis please i have similar problem with VW CANDY and i have bought the C1 cable can you please give me the pdf how to connect c1 on desk to dashboard Segun_solarin@yahoo.com
Quote

Aurimas		2013-08-27 20:04:53
Quote: Ramis please i have similar problem with VW CANDY and i have bought the C1 cable can you please give me the pdf how to connect c1 on desk to dashboard Segun_solarin@yahoo.com <2009 http://www.codecard.lt/carprog/software/carprog-dash/s7-8-vw-2007-by-obd-golf-passat-eos-touran-tiguan-octavia-with-micronas-by-diagnostic/prod_433.html >=2009 http://www.codecard.lt/carprog/software/carprog-dash/s7-14-vw-skoda-seat-2009-dashboards-with-nec-programming-by-obdii/prod_505.html
Quote

chemss eddine		2014-11-20 16:46:20
i have this probléme in carprog 7.55 with dash VW 2010 up+ ps : my carprog is a clone legalised
Quote

ALEKSANDER		2015-01-16 01:07:34
Open dash and read eeprom manualy
Quote

Reply