Alex		2013-03-09 05:31:55
I tried 2 modules on the bench one -2010 escape and second 2011 ford flex modules .When I connect + and _ my power go down from 12.5v to 5.3 . If device show 5 volt ,device not reading and it show error .Make look like it shorted . Pleas help Pleas answer
Quote

Reply

Khaled		2013-04-04 11:46:54
Have you tried to read by obd?
Quote

Khaled		2013-04-04 12:00:29
Do you have onboard diagram and il try with mine to see if i can read
Quote

Alex		2013-04-28 03:38:26
Hi. again after i add 500 ohm resistor it steel not working . By obd2 same think . i tryed on 4 modules .it s go to security -Boot -and Nothing Pleas who can halp ? look like ''Codrcard '' team can not do anything Pleassssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssss
Quote

AMILCAR		2013-06-14 08:46:32
MAKE A A1 TEST....OPEN YOUR A1 AND LOOK IF YOUR A1 HAS TE RESISTOR UPDATES...
Quote

AMILCAR		2013-06-14 08:51:10
Quote: MAKE A A1 TEST....OPEN YOUR A1 AND LOOK IF YOUR A1 HAS TE RESISTOR UPDATES... http://www.codecard.lt/carprog/carprog-repair-kit-4x-74hc125-4x-22uf-capasitors-1x-mcp2515/prod_566.html
Quote

kifah		2014-08-02 07:54:04
Hello every one. I am new in this ford issue . I tried 5 module tile today 08/1/2014 all are failed. I read all notes. after one year, did any one resolve this issue ford SRS can not read it on bench either on car. I need help thanks. my email is : azcarclinic@yahoo.com Keith
Quote

Rossano		2016-11-17 20:37:31
Would it be possible for carprog team to show alternative Board connections for Ford Infineon processor instead of through the Diagnostic pins. Alot of people are having connection problems maybe Board connections would work better for these. i personally cannot read through the pins as it always says connection error and have tried lots of modules and lots of different resistors connecting low and high can wires. its a shame its the only let down. if anybody has any ideas lets here them cheers.
Quote

Reply