Daniel
Hi i have this VW bettle 2000, the client use the car and the next day won't start i see the inmo light blinking, dont read the transponder key i try to program a new key and don't accept programing if anybody is have this trouble before is like the inmo is bad or the antenna please advice me i apreciate att Daniel from Puerto Rico
Quote

Reply

raimis		2007-09-21 09:00:36
hi, what diag equipment you use for key adaptation please? do you have valid PIN code from its immo? regards Raimis
Quote

Daniel		2007-09-21 14:18:50
Hi, yes i have a program that i can read the vag inmo pin code by obd using my laptop then i use the t-code machine to program the key, i have the Vag-com for reset the code using a laptop att Daniel
Quote

james		2007-09-22 00:23:29
did you check the lock time on your t-code for the immo system as if there is a lock time set it wont let you programme the keys even with the correct immo code until the lock time is at zero also check in key that chip is still in it
Quote

Daniel		2007-09-22 01:55:29
how i reset the inmo time do i need a special tool, were i find the inmo box in this car were is the location? its not in zero
Quote

james		2007-09-22 21:14:24
hi daniel you dont need to find the immo box just look at the security info on the t-code and it will tell you if there is a lock time set and for how long or leave ignition switched on for one hour and try to programme keys ive never done a beetle before but most vag cars over here some times wont take a new key when a dash lock is set so maybe it is the same in puerto rico is the immo light like a yellow car ?
Quote

Daniel		2007-09-24 00:36:23
Hi james, yes is yellow hand have a little car and key in the dash like you have in the web page
Quote

Daniel		2007-09-28 01:58:18
Hi James today i try to program the key in the bettle i check the security info with the t-code and say 48 minutes lock then leave the ignition on for 1hour then read the security code is in 0 minutes the try to progran and i can't the check the error code and said ecu inmo:spool, then other code said receiver antenna low signal clear the code an try again and nothing, can i neutralize the inmo to work without transponder i never encouter this problem that my first time. thank you
Quote

Reply