Andy
Hi I am trying to read polo immo with HC05B6 0F10V mask set. I have wired device as in diagram on page 5 of PDF file and have external 10.5v power supply to CARPROG unit but when I try to read it says "external voltage must be in range 9 - 11v" Any idea what problem may be? TIA Andy
Quote

Reply

raimis		2007-11-09 15:25:00
hi, try 10V or 9V if posible, device measures voltage just approxsimately regards Raimis
Quote

eugene		2007-11-10 23:09:47
hi andy i bought multi power supply and just left it at 9v and i read one ok but i tryed another couple and have not been able to get a read let will you let us know how you get on with yours as i think i might be wiring mine wrong thanks eugene
Quote

Andy		2007-11-15 00:31:08
I managed to get it to go to attempt 1, 2, 3, 4, & 5 but not to read, but I find the wiring diagrams confusing in the PDF files. It would be far easier if there was just one diagram of each MCU with colours to attach and showing if any legs need lifting rather than having the photo as well which doesn't really correspond to the diagram or colours. Raimis, Any way of having on board holders to read out of circuit? Andy
Quote

raimis		2007-11-17 09:35:44
hi, yes we think about this solution to desoldering is much easy in some cases adapters should be ready in short run regards Raimis
Quote

Andy		2007-11-21 22:56:26
Excellent news Raimis Andy
Quote

Reply